Reverse Seared Steak (NuWave Bravo XL Smart Oven Heating Instructions)

Ingredients:

Steak, prepared to your preference.

Instructions:

  1. Put a rack on the 3rd rack holder up from the bottom.
  2. Put the Grilling Rack into the Baking Pan.
  3. Spray Cooking Spray on the Grilling Rack.
  4. Place the steak on the Grilling Rack.
  5. Insert the NuWave Bravo Meat Probe into the meat.
  6. Place the Grilling Rack with the Baking pan onto the rack inside the Smart Oven.
  7. Place the Meat Probe connector into the Smart Oven’s Meat Probe jack.
  8. Press the Power On/Off Button, to turn the Smart Oven On.
  9. Press the PROBE Button. Turn the Start Button/Dial, to the desired temperature to start searing. Such as 135° F.
  10. Press the SEAR Button three times, the screen should show “SEAR 2”.
    The 3 Searing Levels on the NuWave Bravo XL Smart Oven Air Fryer are:
    1. Sear 1: [1 press of SEAR button.]
      450°F. for 5 minutes.
      Then 350°F for 10 minutes (adjust as needed).
    2. Sear 1 2: [2 presses of SEAR button.]
      450°F. for 5 minutes.
      Then 350°F for 10 minutes (adjust as needed).
      Then again at 450°F. for 5 minutes.
    3. Sear 2: [3 presses of SEAR button.]
      350°F for 10 minutes (adjust as needed).
      Then 450°F. for 5 minutes. (Reverse Sear)
  11. Press the TIME/TEMP Button to adjust the cooking time. And Turn the Start Button/Dial to 1 hour. This will give the Smart Oven more than enough time to reach the desired temperature to start searing.
  12. Press the Start Button/Dial.
  13. The meat will cook at 350° F. until the desired temperature to start searing is reached. And will then begin searing for 5 minutes at 450° F.
  14. Allow the cooking to complete, but if you see smoke coming from the Smart Oven before cooking is finished, press the ON/OFF Button to immediately stop the cook.
  15. Enjoy!

Subscribe to the Wave Oven Recipes YouTube Channel

Check out my Amazon Page for more great recommendations.